Archive for April, 2013

DIY Remote shutter release for Samsung NX-series cameras

30/04/2013 210 comments

I’m using Samsung NX1000 for aerial photography. The camera has a nifty feature of using smartphone as a remote viewfinder and shutter release but unfortunately the good idea is watered by buggy and limited program and the feature freezes the whole camera all too often. Fortunately there is a simple way of triggering the shutter via cameras usb-port. The trick is to have 68K resistor between ID and GND pins. After this USB data lines can be used to trigger camera focus and shutter.



Tip: If you have spare micro-usb cables, it’s easy to source a connector from the cable that came with the camera. Just squeeze black plastic around the connector with a pliers and the plastic casing will crack open exposing the connector. The connector on the cable has a small pcb, which makes it easy to solder the required resistor in place. If you use smd resistor, the casing can even be reassembled.

The cable described above works fine for manual use, but to use the camera for aerial photography some interface for rc receiver is needed. Fortunately this is easily achieved with a small arduino program, which reads pwm value from receiver servo port and then pulls either shutter or focus line low based on channel value. The compiled code size is under two kilobytes, so it’s possible to use small and inexpensive microcontroller like AtTiny2313.


RC interface for camera

The schematics and sources can be found at:

Compatible with (at least) following models: NX20, NX210, NX1000, NX1100 and NX2000

Update: If you don’t want to make your own, I’m selling these ready made. Just drop me a message.

Shutter PCB's

Shutter PCB’s